Factory-direct-hardware LCN 2035 User Manual download pdf

Hand of door and closer must be the same.

RH or LH will be stamped on mounting plate.

See proper template for your application.

Attach arm to closer, as shown above. The bend

in arm will always point towards door.

Install closer including arm in prepped frame with

mounting screws provided. Be sure mounting plate

is flush with soffit.

After closer is mounted in door jamb, attach applied

stop to head frame, as shown above. Stop section

must have access hole to allow for door closer

adjustment.

7. closing power

Track mortise in top of door must match proper template.

Place roller in track as shown. Mount track in door with holes

for hold open clip toward hinge edge. Fasten with screws

provided.

Open door to approximately 45°. Pull arm over top of door.

Align hole in end of arm with roller stud. Fit closer arm

completely onto roller stud and tighten arm set screw securely.

Adjust only if more power is needed. Closer

is shipped with minimum closing power pre-set. To increase

closing power turn spring adjusting screw clockwise. Maximum

adjustment 36 turns.

2030 SERIES

INSTALLATION INSTRUCTIONS

BACKCHECK

MAIN SPEED

LATCH

SPEED

APPLIED

STOP BY

OTHERS

HOLD OPEN INFORMATION

To install and adjust hold open option, see Fig. 1 and

follow these directions: Tip hold open clip into track.

Locate at desired hold open position and fasten with

screw . Tip cam into track & locate as shown. fasten

with screw . Push door into hold open position and check

for proper operation. To holding power, loosen

screw and slide cam toward latch edge of door. To

holding power, slide cam toward hinge edge. Re-tighten screw .

increase

1 decrease

MAXIMUM

OPENING TORQUE

15 ft-lbs

21 N-m

! - DO NOT USE ABRUPT BACKCHECK- NOR

EXPECT DOOR CLOSER TO ACT AS A DOOR STOP!

CLOSING SPEED:

BACKCHECK:

See Closer Control Diagram below.

Regulating screw locations are shown in illustration at left and

also on door closer label. To adjust Main Speed, turn

regulating screw clockwise to decrease or counter-clockwise

to increase. To adjust Latch Speed, turn regulating screw

clockwise to decrease or counter-clockwise to increase.

This control hydraulically dampens the opening

speed of doors. Use enough backcheck to sufficiently slow the

doors opening speed. To increase resistance, turn

regulating screw clockwise.

8. The 2030 series closer has been regulated prior to

shipment. If adjustments are necessary, carefully follow

instructions. DO NOT REMOVE COVER PLATE TO MAKE

ADJUSTMENTS.

1-800-526-2400

IMPROPER INSTALLATION OR

REGULATION MAY RESULT IN

PERSONAL INJURY OR

PROPERTY DAMAGE. FOLLOW ALL

INSTRUCTIONS CAREFULLY. FOR

QUESTIONS, CALL LCN AT

800 - 526 - 2400

CAUTION

1 2 3 4

2030 SERIES 1

Summary of Contents

Page 1 - 2030 SERIES

1.2.3.4.Hand of door and closer must be the same.RH or LH will be stamped on mounting plate.See proper template for your application.Attach arm to clo

Page 2

Page 3

Page 4

®409/06(85°)

Related models: LCN 2034

Comments to this Manuals

No comments

Factory-direct-hardware LCN 2035 User Manual

Browse online or download User Manual for For Home Factory-direct-hardware LCN 2035. Factory Direct Hardware LCN 2035 User Manual

Summary of Contents

Related models: LCN 2034

Comments to this Manuals

Related products and manuals for For Home Factory-direct-hardware LCN 2035