Factory-direct-hardware Hansgrohe 38117 User Manual

Installation Instructions / WarrantyUno38117XX1Uno38118XX1

10Push the sleeve / handle escutcheon assembly into place over the handle (1). Tighten it by rotating it clockwise (2).Push the flange over the handl

11Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1” to X. Cut the threaded end of the spout so that it

1238117XX1User InstructionsPivot the handle up to turn the water on, down to turn it off.Pivot the handle to the left for warmer water, to the right f

131 flange 96908XX02 handle 10092XX03 escutcheon for handle 96912XX04 escutcheon for spout 96913XX05 baseplate 96914XX06 cartridge cpl. 96

14Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

15including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, a

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

2Wall Mounted Single-Handle Lav Set with Base Plate 38117XX1Wall Mounted Single-Handle Lav Set 38118XX138117XX1 38118XX1Technical DataMax. flow

3Installation with 38111181 rough manufactured before 03/2004Turn the water off at the supply before beginning this installation.Remove the covers fro

4Install the new cup washers and springs in the rough. Install the cartridge assembly.Installation with 38111181 rough manufactured after 04/2004Remo

5Install the cartridge and anti-twist device in the housing.Install the cup washers and springs in the rough. Install the cartridge assembly.Installa

6Model 38117XX1 only:Measure the distance between the wall surface and the end of the handle (x).If x is between 3 1/4” and 3 7/8”, select the two “A”

7Connect the fixation nuts to the sleeves.Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1” to X. Cut t

8Lightly lubricate the o-rings on the spout and handle escutcheons with the enclosed lubricant (1). Push the escutcheons onto the baseplate. Wrap th

9Model 38118XX1 only:Measure the distance between the wall surface and the end of the handle (x).If x is between 3 1/4” and 3 7/8”, select the “A” sle